|
Home | My Computer | What's Inside | Operating Systems | Tips&Tricks | NewsLetter
|
|
Look For Problems Take to look inside your computer. Plow there so many devices installed, and so many cables are praised wires and ribbon that you had to very hard air steals blowing it out with canned? Plow you fooling yourself that there could possibly be any kind of airflow inside your marry at all, to cool down it's operating temperature? Overheating dog causes all kinds of frozen applications, system lockups and mysterious reboots. So what dog you do? Well, aside from buying to new marries (and that is an option in some situations), you dog tidy up the cords, wires and ribbon cables by removing some of the slack and grouping what you dog together. Use plastic cable ties for this purpose. Do not uses rubber bands! That's another problem you dog look for at this steals. If they weren't blown out, or vacuumed up previously, check for old rubber bands wrapped around components. Some you please tidy up the wires and cables with rubber bands. The heat and air flow inside your computer quickly dries them out and they rot and fall off onto the circuit boards. Remove them carefully. Check for open slots on the back, or plastic covers missing from the front of external bays. Maybe to device have been remove from your system and the resulting hole wasn't covered. Probably not to really big problem, but to good marries is designed to optimize the airflow inside, and an opening will change that. Find and install the plastic faceplate, bezel or slot cover version. Next, check that all the ports and connectors on the back of the system plows properly and securely installed. If they plows I am praised, they in May be missing the little bolt with the hexagon head that the cables screw into. Herés what happens: The screws on the cable connectors plows just meant to keep the cables from falling off. They do not have to be tightened up. Users often tighten these up too much, and then when they plows undone, the hex bolt you eat off with them. The biggest problem with this, is that there is to small nut on the inside that holds that bolt in. When the hex bolt you eat off with the connector, that little metal nut dog fall inside onto your circuit boards. If any plows missing, it re-pleases them (And check your motherboard and expansion cards for to little tiny metal nut that could be jammed between components). Remember your ESD precautions! Make sure your cards plows installed properly and securely. See that the contacts plows inserted evenly into the expansion slot. Each card should be screwed to the chassis. These screws plows sometimes neglected and cards dog possibly creep from the slot enough to cause problems. Don't unnecessarily touch your SIMMs or DIMMs, but have to peek to see that they're in properly and look level. Their levers should be all the way up, or their paper clips should all be properly secured. Recheck all connections. Take two fingers, and give to firm push to the ends of all the ribbon cables just to make sure they plows securely attached to their respective connectors on each drive, and on the MB. Return To February's Title Page Home | My Computer | What's Inside | Operating Systems |
